Processor Halt Codes Manual

Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%003012
Cause
A privileged software error occurred—a bad input/output (I/O) segment address was supplied
to the RETURNIOSPACE procedure.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Take a memory dump of the affected processor, collect the required information, and contact
the Tandem NonStop Support Center (TNSC).
%003013
Cause
Corruption occurred in the MAPPOOL system storage pool.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%003014
Cause
An attempt was made to deallocate a currently mapped segment, or there was a bad segment
table entry.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Take a memory dump of the affected processor, collect the required information, and contact
the Tandem NonStop Support Center (TNSC).
%003015
Cause
An unknown segment type was requested, or an illegal segment type occurred in the page table.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Take a memory dump of the affected processor, collect the required information, and contact
the Tandem NonStop Support Center (TNSC).
%003016
Cause
An illegal segment size was passed to the GETSEGMENT procedure.
Standard Processor Halt Code Descriptions 129