Processor Halt Codes Manual

Cause
The input parameter values passed to the quick cell initialization procedure were out of range.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%003043
Cause
The quick cell initialization procedure was unable to lock memory for the quick cell control block.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%003044
Cause
The process segment table (PST) data structure was not aligned at the correct address.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Take a memory dump of the affected processor, collect the required information, and contact
the Tandem NonStop Support Center (TNSC).
%003045
Cause
When a privileged process attempted to call the DEFINEPOOL procedure the low-order bit of
the address was 1. The low-order bit must be zero.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%003046
Cause
An error occurred in the PAGES_SWAP_ procedure. The operating system was trying to swap
pages that were not resident in memory.
Effect
All freeze-enabled processors halt.
Recovery
Take a memory dump of the affected processor, collect the required information, and contact
the Tandem NonStop Support Center (TNSC).
134 Software Halt Code Descriptions