Processor Halt Codes Manual

Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004013
Cause
A privileged software error occurred—a process attempted a BREAKLINK with a link control
block (LCB) not belonging to the process.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004014
Cause
An input/output (I/O) process violated the message system protocol.
Effect
All freeze-enabled processors halt.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004015
Cause
An internal consistency check detected an unexpected problem.
Effect
All freeze-enabled processors halt.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004016
Cause
The linker erroneously modified control words in the link control block (LCB) during message
transmission.
Effect
All freeze-enabled processors halt.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004017
Standard Processor Halt Code Descriptions 141