Processor Halt Codes Manual

%004064
Cause
An error was detected during release of an extended-memory link control block (XLB) or of a
message quick cell (MQC).
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004065
Cause
A link control block (LCB) or an LCB table was bad.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004066
Cause
A $RECEIVE queue was bad.
Effect
All freeze-enabled processors halt.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004067
Cause
A time-list entry was bad.
Effect
All freeze-enabled processors halt.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004070
Cause
A bad read-link cache header or an extended-memory link control block (XLB) was detected.
Effect
The processor halts. The rest of the system is not affected.
146 Software Halt Code Descriptions