Processor Halt Codes Manual

Cause
An error was detected during a process stop.
Effect
All freeze-enabled processors halt.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004076
Cause
An internal consistency check failed in EBSD (a message-system control block that relates to the
Fiber Optic Extension, or FOX, network).
Effect
All freeze-enabled processors halt.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004100
Cause
An internal error occurred because a message quick cell (MQC) with an invalid message
identification was found.
Effect
All freeze-enabled processors halt.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004101
Cause
An internal error occurred because a message-queue bit in the process control block (PCB) was
set when the corresponding queue was empty.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures. .
%004102
Cause
An internal error occurred because a running process tried to send too much global update
(GLUP) data.
148 Software Halt Code Descriptions