Processor Halt Codes Manual

Cause
The regroup algorithm halted the processor because it was not communicating with the other
processors in the system.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004204
Cause
During initialization of the operating system, the message system was not able to allocate sufficient
memory for its internal data structures.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Check to be sure that memory is properly installed. Obtain additional memory if necessary.
%004205
Cause
The send engine is not functioning properly; the amount of time allocated to send packets has
been exceeded.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004206
Cause
An internal consistency check failed while the message system was doing error handling.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004207
Cause
The message system detected that both ServerNet fabrics on the system have been brought
down.
Effect
The processor halts. The rest of the system is not affected.
Standard Processor Halt Code Descriptions 151