Processor Halt Codes Manual

%004413
Cause
The list of ServerNet IDs maintained by the message-system driver is inconsistent with the ServerNet
IDs received from another source.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004414
Cause
A block-transfer-engine negative acknowledgment (BTE NACK) occurred from a message sent
to another processor, and the processor is still functioning.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004415
Cause
An internal consistency check failed while the message-system driver was doing error handling.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%004416
Cause
The list of interrupt, barrier, and probe ServerNet addresses maintained by a processor is
inconsistent with that received from the remote processor during reload. This could be due to
an incorrect version of the T8460 IPM or an internal message system driver error.
Effect
The processor halts. Subsequent attempts to reload will fail with the same halt.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Contact your service provider or
the Global NonStop Solution Center (GNSC), as directed by your local operating procedures.
%004417
Cause
Allocation of ServerNet barrier or interrupt address failed.
156 Software Halt Code Descriptions