Processor Halt Codes Manual

Cause
A LINKMON process encountered an internal error. If you have NonStop TS/MP installed on
your system, a LINKMON process executes in each processor. A LINKMON process is a system
process that enables client and requester processes to access Pathway server classes.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Report this error to your service provider.
%007601
Cause
Not enough virtual memory was available to run $ZNUP. $ZNUP is a process that exists on all
network nodes. It provides a server process in each node to handle network information requests
that concern entities on that node.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%007602
Cause
A logic error occurred within $ZNUP.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%007603
Cause
An unexpected timeout occurred.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%007604
Cause
$ZNUP received an unexpected request.
Effect
The processor halts. The rest of the system is not affected.
194 Software Halt Code Descriptions