Processor Halt Codes Manual

%007711
Cause
A logic error occurred with the system configuration database manager process ($ZCDB).
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Before attempting a memory dump,
contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%007712
Cause
The system configuration database could not be opened during a system-load operation.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Retry the system-load operation with a different configuration database file. If the operation is
still not successful, refer to Processor Halt Monitoring and Recovery (page 10). Take a memory
dump and contact your service provider or the Global NonStop Solution Center (GNSC), as
directed by your local operating procedures.
%007770
Cause
The CONFIG file contains records for two different disk volumes using the specified coldload
paths.
Effect
The processor halts. Since it's the only processor up during coldload, the system halts.
Recovery
Specify four paths that are all used by the same volume in the CONFIG file or four paths that
are not used by any volume in the CONFIG file.
%007771
Cause
The specified coldload paths overlap half, but not all, of the paths to a volume in the CONFIG
file.
Effect
The processor halts. Since it's the only processor up during coldload, the system halts.
Recovery
Specify four paths that are all used by the same volume in the CONFIG file or four paths that
are not used by any volume in the CONFIG file.
%007772
Cause
Fewer than four paths were specified for the coldload volume.
Effect
The processor halts. Since it's the only processor up during coldload, the system halts.
Standard Processor Halt Code Descriptions 197