Processor Halt Codes Manual

Cause
The operator process ($0) was unable to lock down memory in its message queue. For systems
configured with $Z0, a failure occurred in locking down memory for internal data structures.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%010003
Cause
An internal error occurred while $0 was building an event message.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%010004
Cause
An internal error in $0 occurred in the internal memory-pool management.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Before attempting a memory dump,
contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%010005
Cause
For systems configured with $Z0 (compatibility distributor), $Z0 cannot find a destination control
table (DCT) entry for itself, or the data in the entry is incorrect.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Before attempting a memory dump,
contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%010006
Cause
An internal logic error occurred in the $0 process.
Effect
The processor halts. The rest of the system is not affected.
Standard Processor Halt Code Descriptions 199