Processor Halt Codes Manual

Recovery
See Processor Halt Monitoring and Recovery (page 10).
%100212 PON - no operating system image
Cause
The processor thought a power-fail recovery was in progress and tried to restart the operating
system, but the operating system has not been loaded.
Effect
The processor halts. The device load has failed. The rest of the system is not affected.
Recovery
Check your system-load paths and retry the operation. If this operation fails, contact your service
provider or the Global NonStop Solution Center (GNSC), as directed by your local operating
procedures.
%100213 Spurious bus error
Cause
The millicode detected a bus error but could not identify its source.
Effect
The processor halts. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). Before taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100214 TLB exception
Cause
A software error caused the device load to fail.
Effect
The processor halts. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). Before taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100215 Cache error exception
Cause
Hardware may be broken.
Effect
The processor halts. The device load has failed. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). Before taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100222 Watch exception taken
Cause
Someone accessed a memory location specified in the processor watch register.
20 Millicode Halt Code Descriptions