Processor Halt Codes Manual

Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%010007
Cause
Either the $0 or $Z0 process was unable to obtain sufficient memory for the input/output (I/O)
process request manager (IOPRM).
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%010020
Cause
An internal logic error occurred in the $0, $Z0, or $ZOPR process.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%010021
Cause
An internal logic error occurred in the SPI code for the $0, $Z0, or $ZOPR process.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Take a memory dump of the affected processor, collect the required information, and call your
service provider.
%010022
Cause
An internal logic error occurred in the PLF (pre-log filtration) code for the $0, $Z0, or $ZOPR
process.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Take a memory dump of the affected processor, collect the required information, and call your
service provider.
%010023
200 Software Halt Code Descriptions