Processor Halt Codes Manual

%011701
Cause
Either the driver detected errors in the internal driver state or the driver request packet contained
invalid values (such as an odd transfer length).
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%011702
Cause
An unexpected state was found when the state of a disk operation was determined.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%011703
Cause
When the state of a disk operation was being determined, the disk operation had an error.
Wait bits other than INTR, PON, or IOPON were set.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%011705
Cause
An invalid command was specified in the driver request packet.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Take a memory dump of the affected processor, collect the required information, and contact
your service provider
%011706
Cause
A consistency problem was detected by the DP2 driver.
Effect
The processor halts. The rest of the system is not affected.
Standard Processor Halt Code Descriptions 203