Processor Halt Codes Manual

Recovery
Take a memory dump of the affected processor, collect the required information, and contact
your Tandem NonStop Support Center (TNSC).
%012003
Cause
An operations and service processor (OSP) write interrupt occurred with a count less than or
equal to 0.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Take a memory dump of the affected processor, collect the required information, and contact
your Tandem NonStop Support Center (TNSC).
%012004
Cause
The operations and service processor (OSP) process was interrupted with a bad parameter.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Take a memory dump of the affected processor, collect the required information, and contact
your Tandem NonStop Support Center (TNSC).
%012100
Cause
$YMIOP was unable to recognize the master service processors (MSPs).
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%012101
Cause
The maintenance I/O process (MIOP) detected an internal error.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%012102
Cause
A transfer between the maintenance I/O process (MIOP) and the service processor (SP) failed.
Effect
The processor halts. The rest of the system is not affected.
206 Software Halt Code Descriptions