Processor Halt Codes Manual

Effect
The processor halts. The device load has failed. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). Before taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100230 TLB exception failure
Cause
The TLB hardware in the processor is not working and a TLB exception could not be forced. This
message can occur only when the processor is reset.
Effect
The processor reset has failed; the processor halts. The rest of the system is not affected.
Recovery
Replace the processor logic board.
%100232 Reset after error freeze
Cause
A processor that incurred a hardware error freeze was reset. Either the OSM or TSM facility
determined that the processor was “hung” and forced a hardware error freeze so that a dump
can be taken, or the OSM or TSM facility was preparing the processor for a processor dump.
Effect
The processor halts. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100233
Cause
The clean cache lines were not consistent with the memory of a halted processor.
Effect
The processor remains halted. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100235
Cause
A cache error occurred upon entry into the halt loop.
Effect
The processor remains halted. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
Millicode Halt Codes 21