Processor Halt Codes Manual

Recovery
Attempt to take a memory dump. After the dump completes or if taking a dump is not possible,
contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%100277
Cause
There is insufficient memory configured on the processor to support the current software RVU.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Either add more memory to the processor, or revert to an earlier software RVU.
%100300
Cause
A floating-point instruction was received by a system not using a floating-point processor.
Effect
The processor halts. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100301
Cause
The processor millicode has detected a hard abort.
Effect
The processor halts. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100302
Cause
The processor millicode has detected a bus error, but the processor interface chip (PIC) did not
report a bus error in its status.
Effect
The processor halts. The rest of the system is not affected.
Recovery
contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%100303
Cause
The millicode detected an uncorrectable memory error (UCME), but the UCMEs are masked.
Millicode Halt Codes 23