Processor Halt Codes Manual

Cause
A bad address was received from $OSP.
Effect
The processor halts. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100341
Cause
An overflow from INTERRUPT A (INTA) was received.
Effect
The processor halts. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100342
Cause
No millicode was placed in the system during system generation.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%100343
Cause
A cache error occurred on the bus. The processor interface chip (PIC) should have issued a
hardware error to freeze the processor.
Effect
The processor halts. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100344
Cause
Both processors encountered a primary cache error at the same time. This should have resulted
in a hardware error freeze.
Effect
The processor halts. The rest of the system is not affected.
Millicode Halt Codes 29