Processor Halt Codes Manual

Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100404
Cause
The millicode timed out the ServerNet memory interface (SMI) hardware while trying to reset an
interrupt.
Effect
The processor halts. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100405
Cause
An error occurred during the emulation of ServerNet. This halt is usually a result of diagnostics
performed by software development personnel, and is generally not encountered by users.
Effect
The processor halts. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100412
Cause
A bus error exception was reported. A hardware problem might have occurred because bus
errors are not valid for NonStop S-series servers.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%100413
Cause
A privileged process has tried to execute a block INTA call when INTA was already blocked
by a previous call.
Effect
The processor halts. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
32 Millicode Halt Code Descriptions