Processor Halt Codes Manual

Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100432
Cause
An uncorrectable cache error has occurred.
Effect
The processor halts. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100433
Cause
The correctable memory error (CME) scrubber routine has found the block transfer engine (BTE)
idle but locked. The ServerNet code caused an invalid state.
Effect
The processor halts. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100436
Cause
The processor has detected a potential data integrity error.
Effect
The processor halts. The rest of the system is not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100441 Incompatible Hardware/Software
Cause
The RVU software is not compatible with the processor's hardware interface.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Either replace the affected processor with a processor that is supported by the software or cold
load the system with any software RVU that supports the hardware configuration.
%100442 MICROHALT_DIVERGENCE_
Cause
A temporary error in the lockstep process has been detected by the system millicode.
36 Millicode Halt Code Descriptions