Processor Halt Codes Manual

Effect
The processor halts. The rest of the system is not affected.
Recovery
Write down the halt code number, take a memory dump, then contact your service provider or
the Global NonStop Solution Center (GNSC), as directed by your local operating procedures.
%100455 MICROHALT_DIVERGENCE_
Cause
A temporary error in the lockstep process has been detected by the system millicode.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Write down the halt code number, take a memory dump, then contact your service provider or
the Global NonStop Solution Center (GNSC), as directed by your local operating procedures.
%100456 MICROHALT_DIVERGENCE_
Cause
A temporary error in the lockstep process has been detected by the system millicode.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Write down the halt code number, take a memory dump, then contact your service provider or
the Global NonStop Solution Center (GNSC), as directed by your local operating procedures.
%100457 MICROHALT_DIVERGENCE_
Cause
A temporary error in the lockstep process has been detected by the system millicode.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Write down the halt code number, take a memory dump, then contact your service provider or
the Global NonStop Solution Center (GNSC), as directed by your local operating procedures.
%100500
Cause
An internal software error occurred.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Try the processor load or tape dump again. If the problem recurs, contact your service provider
or the Global NonStop Solution Center (GNSC), as directed by your local operating procedures.
%100501
Cause
The block transfer engine reported an error.
Millicode Halt Codes 39