Processor Halt Codes Manual

Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Verify that you have specified the correct slot location for the device that you are trying to access.
Try the processor load or tape dump again. If the problem recurs, contact your service provider
or the Global NonStop Solution Center (GNSC), as directed by your local operating procedures.
%100502
Cause
The block transfer engine reported an error.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Verify that you have specified the correct slot location for the device that you are trying to access;
then retry the processor load or tape dump. If the problem recurs, contact your service provider
or the Global NonStop Solution Center (GNSC), as directed by your local operating procedures.
%100503
Cause
The block transfer engine reported an error.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Verify that you have specified the correct slot location for the device that you are trying to access
and try the processor load or tape dump again. If the problem recurs, contact your service
provider or the Global NonStop Solution Center (GNSC), as directed by your local operating
procedures.
%100504
Cause
The block transfer engine reported an error.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Verify that you have specified the correct slot location for the device that you are trying to access
and try the processor load or tape dump again. If the problem recurs, contact your service
provider or the Global NonStop Solution Center (GNSC), as directed by your local operating
procedures.
%100505
Cause
The block transfer engine reported an error.
40 Millicode Halt Code Descriptions