Processor Halt Codes Manual

Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Verify that you have specified the correct slot location for the device that you are trying to access
and try the processor load or tape dump again. If the problem recurs, contact your service
provider or the Global NonStop Solution Center (GNSC), as directed by your local operating
procedures.
%100506
Cause
The boot section could not be found in the volume label (VLAB) because either the system or
processor was loaded from an incorrect or defective disk.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Verify that you have specified the correct slot location for the device that you are trying to access,
and try the processor load or tape dump again. If the problem recurs, contact your service
provider or the Global NonStop Solution Center (GNSC), as directed by your local operating
procedures.
%100507
Cause
The checksum or eye-catcher was incorrect because either the system or processor was loaded
from an incorrect or defective disk.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Verify that you have specified the correct slot location for the device that you are trying to access,
and try the processor load or tape dump again. If the problem recurs, contact your service
provider or the Global NonStop Solution Center (GNSC), as directed by your local operating
procedures.
%100510
Cause
The processor load timed out waiting for the service processor to upload the configuration table.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Try the processor load or tape dump again. If the problem recurs, contact your service provider
or the Global NonStop Solution Center (GNSC), as directed by your local operating procedures.
%100511
Cause
The processor load timed out waiting for the service processor (SP) to upload the ServerNet
addressable controller (SAC) firmware.
Millicode Halt Codes 41