Manualshelf

Processor Halt Codes Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series
41424344454647484950
Recovery
Try the processor load or tape dump again. If the problem recurs, contact your service provider
or the Global NonStop Solution Center (GNSC), as directed by your local operating procedures.
%100517
Cause
The parameters for a processor or system-load operation were not specified correctly.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Specify whether the processor or system-load operation is from disk or tape, then retry the
operation. If the problem recurs, contact your service provider or the Global NonStop Solution
Center (GNSC), as directed by your local operating procedures.
%100520
Cause
An incorrect response was received from the service processor (SP).
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Try the processor load or tape dump again. If the problem recurs, contact your service provider
or the Global NonStop Solution Center (GNSC), as directed by your local operating procedures.
%100521
Cause
A ServerNet error occurred.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
See Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%100522
Cause
An internal software error occurred: the RELOAD or RCVDMP program asked for too much data
to be pushed or pulled.
Effect
The processor reload or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Try the processor reload or processor dump again.
If the problem recurs during the processor reload, see Processor Halt Monitoring and Recovery
(page 10). Take a memory dump of the system-load processor, the processor that was being
reloaded, and the processor from which the reload operation was being run.
Millicode Halt Codes 43