Manualshelf

Processor Halt Codes Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series
41424344454647484950
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100606
Cause
The millicode cannot read the ServerNet addressable controller (SAC) registers. The ISP controller
is not online because a software failure has occurred.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100607
Cause
After the controller was reset, it did not indicate ready status in mailbox register 0.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100610
Cause
The input /output (I/O) buffer allocation failed because either the access validation and translation
(AVT) table is not available or the processor cache invalidation failed.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100611
Cause
The input/output (I/O) buffer failed because either the access validation and translation (AVT)
table is not available or the processor cache invalidation failed.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
48 Millicode Halt Code Descriptions