Processor Halt Codes Manual

Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100612
Cause
The block transfer engine (BTE) cannot send a packet through ServerNet system area network
(SAN).
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100613
Cause
The timeout period expired during an SCSI operation without having received any
acknowledgment from the ServerNet addressable controller (SAC).
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100615
Cause
The internal queue is full.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100616
Cause
A 2-byte checksum verification failed.
Millicode Halt Codes 49