Processor Halt Codes Manual

Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100617
Cause
A 4-byte checksum verification failed.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100620
Cause
An internal software error has occurred.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100621
Cause
Either the slot location of a tape device was specified for a system-load operation from disk, or
parameters appropriate for a system-load operation from tape were specified while attempting
to load the system from disk.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100622
50 Millicode Halt Code Descriptions