Manualshelf

Processor Halt Codes Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series
51525354555657585960
Cause
The disk block size is not correct; it should be 514 bytes.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100623
Cause
You are using a disk drive not supported by NonStop S-series servers.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access,
and that you are using a supported disk drive. Then retry the operation. If the problem recurs,
contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%100624
Cause
You are using a disk drive not supported by NonStop S-series servers.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access,
and that you are using a supported disk drive. Then retry the operation. If the problem recurs,
contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%100626
Cause
The millicode cannot read the ServerNet bus interface (SBI) control register.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100627
Millicode Halt Codes 51