Processor Halt Codes Manual

Cause
An asynchronous error occurred.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100666
Cause
An asynchronous error occurred.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100667
Cause
An asynchronous error occurred.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100720
Cause
The device to which you are attempting a processor load or tape dump is not responding because
the device is either not powered on, not present at the slot location you specified, or not
communicating properly. Alternately, the SCSI bus might be broken.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
56 Millicode Halt Code Descriptions