Manualshelf

Processor Halt Codes Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series
51525354555657585960
%100760
Cause
Unexpected sense code was received during a SCSI FORMAT operation.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access.
Then retry the operation. If the problem recurs, contact your service provider or the Global
NonStop Solution Center (GNSC), as directed by your local operating procedures.
%100761
Cause
Although an open SCSI request was successfully completed, a CHECK CONDITION status is
still seen on the open SCSI bus.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access.
Then retry the operation. If the problem recurs, insert a new tape, and try the operation again.
If the problem recurs again, contact your service provider or the Global NonStop Solution Center
(GNSC), as directed by your local operating procedures.
%100762
Cause
The end-of-file (EOF) mark was encountered during a tape read operation. The tape might be
defective.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, insert a new tape, and try the operation again. If the
problem recurs again, contact your service provider or the Global NonStop Solution Center
(GNSC), as directed by your local operating procedures.
%100763
Cause
The end-of-data (EOD) mark was encountered during a tape read operation. The tape might be
defective.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, insert a new tape, and try the operation again. If the
Millicode Halt Codes 57