Processor Halt Codes Manual

problem recurs again, contact your service provider or the Global NonStop Solution Center
(GNSC), as directed by your local operating procedures.
%100764
Cause
Fewer than the requested number of bytes have been read from tape, possibly because the
end-of-data (EOD) mark or the end-of-file (EOF) mark was encountered during a tape READ
operation. The tape might be defective.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, insert a new tape, and try the operation again. If the
problem recurs again, contact your service provider or the Global NonStop Solution Center
(GNSC), as directed by your local operating procedures.
%100765
Cause
An early warning condition was encountered during a tape write operation. The tape might be
defective.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, insert a new tape, and try the operation again. If the
problem recurs again, contact your service provider or the Global NonStop Solution Center
(GNSC), as directed by your local operating procedures.
%100766
Cause
A volume overflow occurred during a tape write command. The tape might be defective.
Effect
The processor load or tape dump fails; the processor remains halted. The rest of the system is
not affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, insert a new tape, and try the operation again. If the
problem recurs again, contact your service provider or the Global NonStop Solution Center
(GNSC), as directed by your local operating procedures.
%100767
Cause
An attempt to perform a write operation on a write-protected tape was detected.
58 Millicode Halt Code Descriptions