Processor Halt Codes Manual

Effect
The tape dump fails; the processor remains halted. The rest of the system is not affected.
Recovery
Write-enable the tape, and retry the operation. If the problem recurs, contact your service provider
or the Global NonStop Solution Center (GNSC), as directed by your local operating procedures.
%100770
Cause
A tape is not present in the tape drive.
Effect
The tape dump or device load fails; the processor remains halted. The rest of the system is not
affected.
Recovery
Insert a tape into the tape drive. Check that the tape is properly loaded, online, and write-enabled.
Then retry the operation. If the problem recurs, contact your service provider or the Global
NonStop Solution Center (GNSC), as directed by your local operating procedures.
%100771
Cause
The tag of the interrupt packet received from the ServerNet addressable controller (SAC) does
not match the tag of the command packet sent to the ServerNet addressable controller (SAC),
because the packet content might be corrupted.
Effect
The tape dump or device load fails; the processor remains halted. The rest of the system is not
affected.
Recovery
If you are attempting a tape dump, check that a tape is loaded, online, and write enabled. Then
retry the tape dump. Check that the slot location was specified correctly for the device you are
trying to access, and retry the operation. If the problem recurs, contact your service provider or
the Global NonStop Solution Center (GNSC), as directed by your local operating procedures.
%100772
Cause
The tag of the interrupt packet received from the ServerNet addressable controller (SAC) does
not match the tag of the command packet sent to the ServerNet addressable controller (SAC).
The tag matches that of the previous command, because the ServerNet addressable controller
(SAC) resent the previous packet.
Effect
The tape dump or device load fails; the processor remains halted. The rest of the system is not
affected.
Recovery
If you are attempting a tape dump, check that a tape is loaded, online, and write enabled. Then
retry the tape dump. Check that the slot location was specified correctly for the device you are
trying to access, and retry the operation. If the problem recurs, contact your service provider or
the Global NonStop Solution Center (GNSC), as directed by your local operating procedures.
%100773
Cause
The device is returning BUSY SCSI status after a number of retries.
Millicode Halt Codes 59