Processor Halt Codes Manual

Effect
The tape dump or device load fails; the processor remains halted. The rest of the system is not
affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100774
Cause
A SCSI error has occurred.
Effect
The tape dump or device load fails; the processor remains halted. The rest of the system is not
affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100775
Cause
A SCSI error has occurred.
Effect
The tape dump or device load fails; the processor remains halted. The rest of the system is not
affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%100777
Cause
A SCSI error has occurred.
Effect
The tape dump or device load fails; the processor remains halted. The rest of the system is not
affected.
Recovery
Check that you specified the correct slot location for the device you are attempting to access. If
attempting a tape dump, check that the tape is properly loaded, online, and write-enabled. Then
retry the operation. If the problem recurs, contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%123456
Cause
This is the initialization value for the SD halt register memory location. When it appears in a
memory dump, this value indicates that no halts have occurred.
60 Millicode Halt Code Descriptions