Processor Halt Codes Manual

Effect
The processor load fails; the processor remains halted.
Recovery
Check that you specified the correct configuration for load and ensure that the Fibre Channel
cable is properly connected. Then, retry the operation. If the problem recurs, contact your service
provider or the Global NonStop Solution Center (GNSC), as directed by your local operating
procedures.
%100736 MICROHALT_BOOT_FC_ERROR
Cause
A Fibre Channel Adapter or NonStop Storage CLIM error has occurred during system load.
Effect
The processor load fails; the processor remains halted.
Recovery
Check that you specified the correct configuration for load. Then, retry the operation. If the
problem recurs, contact your service provider or the Global NonStop Solution Center (GNSC),
as directed by your local operating procedures.
%100737 MICROHALT_BOOT_DEVICE_NOT_FOUND
Cause
A Fibre Channel Adapter or NonStop Storage CLIM error has occurred during system load.
Effect
The processor load fails; the processor remains halted.
Recovery
Check that you specified the correct configuration for load. Then, retry the operation. If the
problem recurs, contact your service provider or the Global NonStop Solution Center (GNSC),
as directed by your local operating procedures.
%100740 MICROHALT_BOOT_DEVICE_ERROR
Cause
A Fibre Channel Adapter or NonStop Storage CLIM error has occurred during system load.
Effect
The processor load fails; the processor remains halted.
Recovery
Check that you specified the correct configuration for load. Then, retry the operation. If the
problem recurs, contact your service provider or the Global NonStop Solution Center (GNSC),
as directed by your local operating procedures.
%100741 MICROHALT_BOOT_ADAPTER_FIRMWARE
Cause
A Fibre Channel Adapter or NonStop Storage CLIM error has occurred during system load.
Effect
The processor load fails; the processor remains halted.
Recovery
Check that you specified the correct configuration for load. Then, retry the operation. If the
problem recurs, contact your service provider or the Global NonStop Solution Center (GNSC),
as directed by your local operating procedures.
H-Series and J-Series Codes 63