Processor Halt Codes Manual

Recovery
Check that you specified the correct configuration for load. Then, retry the operation. If the
problem recurs, contact your service provider or the Global NonStop Solution Center (GNSC),
as directed by your local operating procedures.
%102200 MICROHALT_HARD_RESET
Cause
The software has detected an inconsistency and reset the processor.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Write down the halt code and contact your service provider or the Global NonStop Solution
Center (GNSC), as directed by your local operating procedures.
%102201 MICROHALT_HALT_WATCHDOG2
Cause
The second level watchdog timer has expired and the hardware has reset the processor.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Write down the halt code and contact your service provider or the Global NonStop Solution
Center (GNSC), as directed by your local operating procedures.
%102202 MICROHALT_HALT_WATCHDOG3
Cause
The third level watchdog timer has expired and the hardware has reset the processor.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Write down the halt code and contact your service provider or the Global NonStop Solution
Center (GNSC), as directed by your local operating procedures.
%102203 MICROHALT_HALT_HSS_INTERNAL_ERR
Cause
A processor reset has occurred due to either a software error or inconsistency.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Take a memory dump, and contact your service provider or the Global NonStop Solution Center
(GNSC), as directed by your local operating procedures.
%102204 MICROHALT_HALT_FLASH_READ_ERROR
Cause
An error occurred while reading flash.
Effect
The processor halts. The rest of the system is unaffected.
H-Series and J-Series Codes 65