Manualshelf

Processor Halt Codes Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series
61626364656667686970
Effect
The processor halts, and the ServerNet links to this NonStop Kernel logical processor are brought
back up. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump. After the
dump completes, do a "Hard Reset" on this NonStop Kernel logical processor. This reset can
be accomplished using the Onboard Administrator (OA) or OSM Low-Level Link (LLL), to ensure
complete clean-up of and recovery from the MCA. The processor can be reloaded after it has
come back up to the Power-On (PON) Halt (%100212 halt code). If the processor fails to come
back up to the PON Halt, then it must be replaced. If the subsequent attempt to reload the
processor results in another halt, then the processor should be scheduled for replacement at the
earliest convenience. Contact your service provider or the Global NonStop Solution Center
(GNSC), as directed by your local operating procedures.
%102266 MICROHALT_HSS_DEBUG_USE
Cause
HSS encountered an incorrect halt code.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102267 MICROHALT_HSS_UNSUPPORTED_HALTCODE
Cause
HSS encountered an incorrect halt code.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102277 MICROHALT_HALTCODE_NOT_TOBE_USED
Cause
Inconsistent state for halted processor.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102300 MICROHALT_BTE_RESERVED_VALUE
Cause
The millicode detected an internal inconsistency.
H-Series and J-Series Codes 69