Processor Halt Codes Manual

%102406 MC_FAULT_CANONICAL_UNLOCK_ERROR
Cause
Millicode detected an error associated with unlocking a canonical lock (trying to release a lock
owned by another process).
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102407 MC_FAULT_INITIALIZE_MTCB_FAILURE
Cause
Millicode detected a failure associated with initialization of the MTCB (alignment problem).
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102410 MC_FAULT_EMPTY_READY_LIST
Cause
Millicode detected an empty ready list in Dispatch.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102411 MC_FAULT_RELEASE_OWNERSHIP_ERROR
Cause
Millicode detected an error associated with releasing ownership of the MTCB during process
hand-off.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102412 MC_FAULT_LOCK_CANT_WAIT
Cause
Millicode detected a situation where it could not wait for the lock whose canonical order is too
high to allow waiting.
72 Millicode Halt Code Descriptions