Processor Halt Codes Manual

Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102413 MC_FAULT_CANT_BE_HERE
Cause
Millicode detected a state that should not occur.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102414 MC_FAULT_CANT_OWN_IP
Cause
Millicode detected an attempt to take ownership of an Interrupt Process.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102415 MC_FAULT_LOCK_INCONSISTENCY
Cause
The millicode detected an internal inconsistency with regard to a lock.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102416 MC_FAULT_SHOULD_NEVER_RUN
Cause
Millicode detected a situation where a process is running that should not be running.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102417 MC_FAULT_GIVE_SELF_TO_GFH
H-Series and J-Series Codes 73