Processor Halt Codes Manual

Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102424 MC_FAULT_CANNOT_GIVE_SELF_TO_IP
Cause
Millicode detected a problem with a process passing ownership to an Interrupt Process.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102425 MC_FAULT_NSK_BAD_SECTION
Cause
NonStop Kernel called the function $n_NSK_End_Init with a bad section number.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102426 MC_FAULT_CANT_PASS_IP_TO_GFH
Cause
Millicode detected an attempt to pass ownership of an Interrupt Process to GFH.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102427 MC_FAULT_CANT_PASS_LOCK_HOLDER_TO_GFH
Cause
Millicode detected an attempt to pass ownership of a process that is holding locks to the GFH.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102430 MC_FAULT_BRK_HALT
Cause
Millicode executed a break halt.
H-Series and J-Series Codes 75