Processor Halt Codes Manual

Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102507 MC_FAULT_SM_IP_NOT_RUNNING
Cause
Millicode detected that an Interrupt Process is not running.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102510 MC_FAULT_ILLEGAL_HSS_ACTION
Cause
Millicode did not recognize the specified action code.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump. After the
dump completes, perform a “Hard Reset" on this NonStop Kernel logical processor. This reset
can be accomplished using the Onboard Administrator (OA) or OSM Low-Level Link (LLL), to
ensure complete clean-up of and recovery from the failure. The processor can be reloaded after
it has come back up to the Power-On (PON) Halt (%100212 halt code). If the subsequent attempt
to reload the processor results in another halt, then the processor should be scheduled for
replacement at the earliest convenience. Contact your service provider or the Global NonStop
Solution Center (GNSC), as directed by your local operating procedures.
%102511 MC_FAULT_NESTED_PAGE_FAULT
Cause
Millicode detected a nested page fault.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102512 MC_FAULT_NO_SPACE_PRIV_STK
Cause
Millicode detected that there is insufficient space available on the privileged stack.
Effect
The processor halts. The rest of the system is unaffected.
86 Millicode Halt Code Descriptions