Processor Halt Codes Manual

Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102513 MC_FAULT_NO_SPACE_PRIV_RSE_STK
Cause
Millicode detected that there is insufficient space available on the privileged RSE stack.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102514 MC_FAULT_NSK_BAD_VPTE
Cause
Millicode detected an invalid virtual page table entry.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102515 MC_FAULT_UNCOOPERATIVE_PROCESS
Cause
The millicode detected an uncooperative process.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102516 MC_FAULT_READY_QUEUE_CORRUPTION
Cause
Millicode detected a Ready list queue invalid index.
Effect
The processor halts. The rest of the system is unaffected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%102517 MC_FAULT_READY_QUEUE_CORRUPTION_LINK
Cause
Millicode detected a Ready list queue invalid link.
H-Series and J-Series Codes 87