ProCurve Series 2300 and 2500 Switches Release Notes

Enhancements in Release F.05.xx

Isolated Port Groups (Enhanced)

See Figure 3 below for an example of adding an additional Syslog server.

Figure 3. Configuring multiple Syslog Servers

Operating Notes for Syslog

■ Rebooting the switch or pressing the Reset button resets the Debug Configuration. Any Syslog

server IP addresses written in the startup-config file are saved across a reboot and logging

remains enabled. Any Syslog server IP addresses existing only in the running-config file are lost

if the switch reboots. (Use the write memory command to save configuration changes to the

Startup-config file.)

■ Up to six Syslog servers may be configured to receive Event Log messages. All switches must

use the same Syslog facility.

Isolated Port Groups (Enhanced)

Isolated Port-Group Commands

[no] port-isolation page 15

port-isolation [ethernet] < port-list > mode

page 15

show port-isolation page 15

Continuing the example begun in

figure 2, this command adds a

second Syslog server.

Lists the IP addresses of the Syslog

servers configured on the switch.

Messages must be sent to the

same facility on each Syslog server