ProCurve Series 2300 and 2500 Switches Release Notes

243
Software Fixes
■ CLI — The CLI command "show tech" causes an error message when the command is
executed from within config mode.
■ CLI — The prompt for saving the config does not handle a DISC character appropriately.
■ CLI/Timezone — The switch time is wrong if CLI used to set timezone and timezone may
not operate properly after switch is rebooted. West of GMT is now a negative offset and east
of GMT is now a positive offset.
■ Crash — If dynamic trunks are configured and the switch is rebooted, the switch may crash
with a message similar to:
->Software exception at rstp_dyn_reconfit.c:243 in -- 'Lpmgr'
■ Crash — The "show config" CLI command may cause the switch to crash with a message
similar to:
->Software exception "xlate.c:1358 in 'mSess1'
■ Crash — When hot-swapping transceivers multiple times, the switch may crash with a
message similar to:
-> Software exception at port_sm.c:378 in -- 'mPmSlvCtrl'
■ Crash — The switch may crash with a message similar to:
-> Software exception at alloc_free.c:545 -- in 'eDrvPoll'
■ Crash — The switch may crash with a message similar to:
->Asserts in rv.cc line 632
■ Crash — When adding ports to a manual LACP trunk configuration, the switch may crash
with a message similar to:
-> Assert line 10070 cli_config_action.c
■ Crash — The switch may crash with a message similar to:
-> Bus Error: HW Addr=0x0000000 IP=0x002fe640 Task='eTelnetd'
This crash has been associated with security/vulnerability test applications such as Nessus.
■ Event Log — Log messages for trunks and trunk members enhanced to be easier to read.
■ GVRP — Upstream GVRP neighbor does not pass VLAN information to downstream
neighbor after a topology change.
■ IGMP — Interoperability issues with some Cisco devices (such as some Cisco Catalyst 5000
& 6000 series switches) cause IGMP groups to be aged out of the switch's IGMP tables
prematurely.