ProCurve Series 2300 and 2500 Switches Release Notes

18
Enhancements in Release F.05.xx
Isolated Port Groups (Enhanced)
Figure 6. Example of Port-Isolation Configuration
Uplink mode is the default setting for all ports when you enable port-isolation.
Since these two ports were not explicitly configured, above, they remain in
the Uplink mode (and do not need to be explicitly configured as uplinks).
When you enter the command to enable port
isolation, the switch displays a caution and
prompts you to indicate how to proceed. Type
[Y] to continue with enabling port isolation; [N]
to leave port isolation disabled. See the Caution
on page 12.
Remember to disable LACP on ports that will be configured
for Public, Group1, Group2, Private, or Local mode. (Refer
to “Operating Rules for Port Isolation” on page 13.)