ProCurve Series 2300 and 2500 Switches Release Notes

51
Enhancements in Release F.05.xx
Configuring Port-Based Access Control (802.1x)
Displaying 802.1x Configuration, Statistics, and Counters
Show Commands for Port-Access Authenticator
802.1x Authentication Commands page 28
802.1x Supplicant Commands page 47
802.1x Open VLAN Mode Commands page 34
802.1x-Related Show Commands
show port-access authenticator below
show port-access supplicant page 56
Details of 802.1x Mode Status Listings page 53
RADIUS server configuration pages 33
Syntax: show port-access authenticator [[e] < port-list >]
[config | statistics | session-counters]
•Without [< port-list > [config | statistics | session-
counters]], displays whether port-access
authenticator is active (Yes or No) and the status of
all ports configured for 802.1x authentication. The
Authenticator Backend State in this data refers to the
switch’s interaction with the authentication server.
•With < port-list > only, same as above, but limits port
status to only the specified port. Does not display
data for a specified port that is not enabled as an
authenticator.
•With [< port-list > [config | statistics | session-counters]],
displays the [config | statistics | session-counters] data
for the specified port(s). Does not display data for a
specified port that is not enabled as an authenticator.
•With [config | statistics | session-counters] only,
displays the [config | statistics | session-counters] data
for all ports enabled as authenticators.
For descriptions of [config | statistics | session-counters]
refer to the next section of this table.