ProCurve Switches 2512 and 2524 Management and Configuration Guide
7-37
Using Passwords, Port Security, and Authorized IP Managers To Protect Against Unauthorized Access
Using IP Authorized Managers
Using Passwords, Port 
Security, and Authorized IP 
Table 7-2. Analysis of IP Mask for Single-Station Entries
Configuring Multiple Stations Per Authorized Manager IP 
Entry
The mask determines whether the IP address of a station on the network meets 
the criteria you specify. That is, for a given Authorized Manager entry, the 
switch applies the IP mask to the IP address you specify to determine a range 
of authorized IP addresses for management access. As described above, that 
range can be as small as one IP address (if 
255 is set for all octets in the mask), 
or can include multiple IP addresses (if one or more octets in the mask are set 
to less than 
255).
If a bit in an octet of the mask is “on” (set to 1), then the corresponding bit in 
the IP address of a potentially authorized station must match the same bit in 
the IP address you entered in the Authorized Manager IP list. Conversely, if a 
bit in an octet of the mask is “off” (set to 0), then the corresponding bit in the 
IP address of a potentially authorized station on the network does not have to 
match its counterpart in the IP address you entered in the Authorized Manager 
IP list. Thus, in the example shown above, a “255” in an IP Mask octet (all bits 
in the octet are “on”) means only one value is allowed for that octet—the value 
you specify in the corresponding octet of the Authorized Manager IP list. A “0” 
(all bits in the octet are “off”) means that any value from 0 to 255 is allowed 
in the corresponding octet in the IP address of an authorized station. You can 
also specify a series of values that are a subset of the 0-255 range by using a 
value that is greater than 0, but less than 255.
1st 
Octet
2nd 
Octet
3rd 
Octet
4th 
Octet
Manager-Level or Operator-Level Device Access
IP Mask 255 255 255 255 The “255” in each octet of the mask specifies that only the exact value in 
that octet of the corresponding IP address is allowed. This mask allows 
management access only to a station having an IP address of 10.33.248.5.
Authorized 
Manager IP
10 28 227 125










