PTrace Reference Manual

PTrace Commands
PTrace Reference Manual—526393-001
3-6
DETAIL Command
Ptrace Select Key: All except the following:
LCB OCB
?SELECT (ACSE,ASNI,L5) Selects the keywords ACSE, ASNI, and L5.
Ptrace Select Key: ACSE ASNI L5
?DESELECT (ASNI,L5) Deselects the keywords ASNI and L5.
Ptrace Select Key: ACSE
DETAIL Command
The DETAIL command controls the level of detail of the information displayed by
PTrace. The specific action of the DETAIL command depends on the subsystem for
which PTrace is displaying records.
ON
causes additional detailed information to be displayed.
OFF
causes the most detailed information to be suppressed.
Considerations: DETAIL Command
•
If the DETAIL command is not used, OFF is assumed.
•
If DETAIL is specified without ON or OFF, ON is assumed.
•
The RESET and FROM commands set the DETAIL command to OFF.
EBCDIC Command
Use the EBCDIC command to select either EBCDIC or ASCII character equivalents
when displaying trace records with HEX or OCTAL enabled.
ON
enables EBCDIC conversion.
OFF
disables EBCDIC conversion. (The ASCII character set is used instead.)
DETAIL [ ON ]
[ OFF ]
EBCDIC [ ON ]
[ OFF ]