RDF 1.3 IMPX README

e. Review the host file location of each file to be placed on
your server.
f. When you reach the Installation Manifest screen, you are given
the DSV and ISV locations.
g. You are now prompted to initiate the movement of the files
to the target locations. Continue as prompted.
h. When the installation has completed, click on FINISH.
i. The installation process has moved the NonStop RDF/IMP,
NonStop RDF/IMPX and NonStop LockStep Gateway
softdocs to $SYSTEM.SOFTDOC. The softdocs are named
T0346A03, T0347D42 and T1226D46.
j. Refer to the softdocs to complete the final steps of
installation.
IMPORTANT: Always reinstall this product after using the Tandem
Install product to install a Site Update Tape (SUT).
Installing a SUT using the Install product can result in
overwriting this Independent Product with older versions of
software. This problem does not occur when using DSM/SCM
to install SUTs.
7. Follow the post-installation instructions in Section III below, if
any, after using IPSetup to place and install this product.
II. Pre-Installation Instructions
None
III. Post-Installation Instructions
None
IV. Product Requirements
Required Hardware: NonStop RISC-based servers
Minimum OS Release:
Please see the SOFTDOCs for both the NonStop RDF/IMP and
NonStop RDF/IMPX products. These are discussed in step i
above.
Required Software:
Please see the SOFTDOC for both the NonStop RDF/IMP and
NonStop RDF/IMPX products. These are discussed in step i
above.
Disk Space Requirement:
15 MB on DSV
15 MB on ISV
15 MB per each RDF installation
V. Installation Prerequisites
Required Hardware:
Tandem NonStop RISC-based server
file:///C|/Documents and Settings/DEicher/Desktop/RDFIMPX 1.3 README.TXT
file:///C|/Documents and Settings/DEicher/Desktop/RDFIMPX 1.3 README.TXT (2 of 4) [6/23/2004 11:39:29 AM]