RDF 1.4 IMP README

the DSV and ISV locations.
g. You are now prompted to initiate the movement of the files
to the target locations. Continue as prompted.
h. When the installation has completed, click on FINISH.
i. The installation process has moved the NonStop RDF/IMP softdoc
to $SYSTEM.SOFTDOC. The softdoc is named T0346A04.
j. Refer to the softdoc to complete the final steps of
installation.
This product contains both NonStop Kernel components and workstation
components. You must place each component type separately. To
restart the installation program after placing the first component
type, click SETUP.EXE in the root directory.
IMPORTANT: Always reinstall this product after using the
Install product to install a Site Update Tape (SUT).
Installing a SUT using the Install product can result in
overwriting this Independent Product with older versions of
software. This problem does not occur when using DSM/SCM
to install SUTs.
7. Follow the post-installation instructions in Section III below, if
any, after using IPSetup to place and install this product.
II. Pre-Installation Instructions
None
III. Post-Installation Instructions
None
IV. Product Requirements
Required Hardware:
NonStop RISC-based servers
Minimum OS Release:
Please see the SOFTDOC for the approriate release, which
is discussed in step i above.
Required Software:
Please see the SOFTDOC for the approriate release, which
is discussed in step i above.
Disk Space Requirement:
15 MB on DSV
15 MB on ISV
15 MB per each RDF installation
V. Installation Prerequisites
Required Hardware:
NonStop RISC-based server
Communications controller allowing file transfer
from PC to NonStop RISC-based server
file:///C|/Documents and Settings/DEicher/Desktop/RDF1^4ImpReadme.txt
file:///C|/Documents and Settings/DEicher/Desktop/RDF1^4ImpReadme.txt (2 of 3) [6/17/2004 1:10:09 PM]