RDF System Management Manual

Operating and Monitoring RDF
HP NonStop RDF System Management Manual—524388-003
4-11
Using RDFCOM Commands
Utility Commands
RDFCOM utility commands and their functions are listed in Table 4-3. All of these
commands can be issued by anyone.
Entering Commands
The complete syntax of all RDFCOM commands appears in Section 8, Entering
RDFCOM Commands. Some general rules that apply to all RDFCOM commands
appear in the following list:
•
You can enter commands in either uppercase or lowercase letters or any
combination of these.
•
RDFCOM reads command lines up to 132 characters (bytes) long; if the maximum
line length of your input device is less than 132 characters, and your command
input exceeds the device’s limit, the input will wrap around to the next line but will
terminate when 132 characters have been read. RDFCOM does not support
additional entry lines or special command continuation characters.
•
RDFCOM supports a comments character (vertical bar) within command entry
lines or within OBEY command files.
Table 4-3. RDFCOM Utility Commands
Command Object Function
EXIT - - Terminates an RDFCOM session.
FC - - Enables you to edit (fix) a previously issued
command.
HELP {ABBREVIATIONS }
{ALL }
{command }
{message-number}
Displays help text for commands and messages.
HISTORY - - Displays the 10 most recently issued RDFCOM
commands.
OBEY filename Causes RDFCOM to read commands from the
specified command file.
OPEN control-subvolume Sets the RDF control subvolume to
$SYSTEM.control-subvolume, thereby setting up
RDF for access to that configuration.
OUT filename Redirects subsequent session output to the
specified device or file.