RDF System Management Manual

Entering RDFCOM Commands
HP NonStop RDF System Management Manual—524388-003
8-25
Command Overview
When you enter the ? or ! character instead of the keyword FC, the requested
command appears but you are not prompted for subcommands to change it; use the ?
or ! when you only wish to display the command, not change it.
The FC command is a standard feature of many HP software products. For more
information about how to use this command, see the TACL Reference Manual.
Examples
Suppose you enter the INFO MONITOR command, but mistype the second character
in MONITOR and receive an error message as a result:
]INFO MINITOR
Expecting: RDF, MONITOR, EXTRACTOR, RECEIVER, PURGER, IMAGETRAIL
Or: NETWORK, RDFNET, TRIGGER, VOLUME, "*" or a Volume name
]
You can correct this mistake by entering the FC command, which redisplays the INFO
MONITOR command as you erroneously entered it, followed by a prompt for your R, I,
or D subcommand or replacement character:
]FC
]INFO MINITOR
.
To correct the entry, following the subcommand prompt, enter the replacement
character O under the incorrect letter (I) that appears on the previous line, and then
press the Return key (or its equivalent) to transmit the correction:
]INFO MINITOR
. O
RDF now displays the corrected INFO MONITOR command followed by another
prompt that asks for any further corrections. Because you have no further changes,
you press the Return key after the subcommand prompt. Now, RDFCOM processes
the INFO MONITOR command, this time successfully.
]INFO MONITOR
.
MONITOR CPUS 0:1
MONITOR PRIORITY 170
MONITOR PROCESS $MON
]
On the next line, suppose you inadvertently enter an extra character in the SHOW RDF
command:
]SHOW RDDF
Expecting: RDF, MONITOR, EXTRACTOR, RECEIVER, PURGER, IMAGETRAIL
Or: NETWORK, RDFNET, TRIGGER, or VOLUME
]